MAXv Multi-Axis Motion Controller

The MAXv is a VME/VME64 8-axis motion controller for stepper and/or motor control.  The MAXv supports connections on both the VME/VME64 bus P2 connector as well as connectors on the front panel.  Each axis can be selected by the user to be an open or closed stepper, or a servo axis.  Outputs are provided for 16 bit analog servo output as well as step and direction for stepper system applications.  The servo loop is a PID filter with feed-forward coefficients and an update rate of 122 ms on all 8 axes.  An additional 16 User Definable I/O is available for synchronization and control of other events.  In addition, independent analog inputs are provided for requirements such as velocity override, temperature, pressure, etc., under the control of the running application.  Encoder feedback, differential or single ended, is used for all servo axes and is available for position feedback and may also be used for slip or stall detection.  Two additional auxiliary encoder inputs are available for increased precision and control.  Two additional general purpose analog outputs are also available.  The bus interface uses Shared Memory technology for communication of commands from the host and feedback of motion control parameters.  Commands may be written to this Shared Memory by the host, eliminating the communication bottlenecks of single address port-based communications.

• PID update rate of 122 ms on all 8 axes
• Configurable PID filter with feed forward coefficients.
• 4032 Bytes of Dual Port RAM provides rapid data transfers
• Motion parameters continuously available in shared RAM for real time profile status.
• Designed to accommodate expandability to unique and custom applications.
• The 160-pin P1/P2 connectors provide high density connectivity on the back plane.
• 6 Channels of general purpose analog input with 16 bit, +/-10 VDC input
• 2 Channels of general purpose analog output with 16-bit +/-10 VDC output.
• Support Quadrature Encoder Feed back up to 16 MHz on up to 10 encoder inputs.
• Step pulses from 0 to 4,176,000 steps per second (+/- 0 steps).
• Backlash compensation.
• Custom, parabolic, “S”-Curve & linear trajectory profiles.
• Real time encoder position capture.
• S-Curve with 4-quadrant jerk parameters.
• Two 68-pin SCSI and one 50-pin SCSI connectors for high density signal connection on the front panel.

ACCESSORIES

IOvMAX      I/O Breakout Board for MAXv
CBL68-10  I/O cable for MAXv, 68-pin, 10ft
CBL50-10  I/O cable for MAXv, 50-pin, 10ft

PDF Documents